Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
431
The statistics are displayed.
You enable MLD snooping with the ipv6 mld snooping command.
You reset the counters to zero with the
ipv6 mld snooping clear counters command.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
ipv6 mld snooping
Description
With this command, you enable MLD snooping on the device or on the required VLAN.
For MLD snooping to work, you need to enable the function globally and in the VLANs. In the
Global configuration mode, enable MLD snooping on the device or globally. To enable MLD
snooping on the required VLAN, execute the command in the VLAN configuration mode.
● GMRP is disabled.
● You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Call the command without parameter assignment:
ipv6 mld snooping
To Next Page
Loading...
Need help?
General