Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
572 Configuration Manual, 11/2015, C79000-G8976-C252-10
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you enable routing with VRRPv3 and change to the VRRP3 Router
configuration mode.
Note
This command is available only with layer 3.
● IPv6 routing is enabled.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
router vrrp3
Routing with VRRP3 is enabled.
You are now in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
You disable routing with VRRP with the no router vrrp3 command.
You enable IPv6 routing with the
ipv6 unicast-routing command.
You configure an IPv6 address for the interface with the
ipv6 address command.
To Next Page
Loading...
Need help?
General