Security and authentication
11.1 User management
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
679
This command shows the user name of the logged in user.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
whoami
The user name of the logged in user is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you create roles that are valid locally on the device.
Note
You can create up to 28 additional roles.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General