Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
311
Call up the command with the following parameters:
show ipv6 dhcp interface [{vlan <vlan-id(1-4094)> | <interface-type> <interface-
id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The information is displayed.
show ipv6 dhcp pd sub-client interfaces
Description
This command shows the configuration of the DHCPv6 PD sub-client
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameter assignment:
show ipv6 dhcp pd sub-client interfaces
The information is displayed.
To Next Page
Loading...
Need help?
General