Load control
10.2 Static MAC filtering
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
660 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
no mac
-address-table static unicast <aa:aa:aa:aa:aa:aa>
vlan<vlan-id(1-4094)>
The parameters have the following meaning:
MAC address of the interface
Keyword for a VLAN connection -
Number of the addressed VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The entry is deleted from the forwarding database.
With the show mac-address-table static unicast command, you display the list of
configured entries.
With the
mac-address-table static unicast command, you create an entry.
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
switchport ingress-filter
Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
To Next Page
Loading...
Need help?
General