Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
484 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
The type of authentication is reset.
Further notes
You enable the authentication with the ip ospf authentication command.
9.2.4.3
ip ospf authentication-key
Description
With this command, you specify the password.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf authentication-key <password (8)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
Password
Password Enter a password.
Maximum length: 8 characters
Result
The password is specified.
Further notes
You delete the password with the no ip ospf authentication-key command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English