Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
173
Call up the command with the following parameters:
show mac-address-table count[vlan<vlan-id(1-4094)>]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
If you do not select any parameter from the parameter list, the total number of entries is
displayed for all VLANs.
The number of MAC addresses for the selected VLAN is displayed.
show subnet-vlan mapping
Description
This command shows the entries of a subnet VLAN table.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show subnet-vlan mapping
[{interface<interface-type><interface-id>|switch<string(32)>}]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, all entries are displayed.
To Next Page
Loading...
Need help?
General