Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
747
The guest VLAN function is enabled for the device.
You also need to enable the guest VLAN function for the device. You do this with the dot1x
guest-vlan
command in the Global configuration mode.
You disable the function with the
no dot1x guest-vlan command
no dot1x guest-vlan
Description
With this command, you disable the guest VLAN function for a port.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no dot1x guest-vlan
The guest VLAN function is disabled for the device.
dot1x guest-vlan vlan-id
Description
With this command, you configure a guest VLAN for a port.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
To Next Page
Loading...
Need help?
General