Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
295
The IPv6 address is assigned to the interface.
You delete the IPv6 address with the no ipv6 address command.
You enable IPv6 with the
ipv6 enable command.
You display this setting and other information with the
show ipv6 interface command.
You display the IPv6 address of the DHCP PD sub-client with the
show ipv6 dhcp sub-client
interfaces.
command.
You enable prefix delegation with the
ipv6 address dhcp command.
You enable stateless DHCPv6 autoconfiguration with the ipv6 address dhcp stateless
command
no ipv6 address
Description
With this command, you delete the IPv6 address.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
To Next Page
Loading...
Need help?
General