System time
5.1 System time setting
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
146 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
show dst info
The entries for daylight saving time are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you configure the way in which the system time is obtained.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General