Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
528 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.3.3.15
no redist-config
Description
With this command, you delete the information for the new external routes.
Note
This command is available only with layer 3.
Requirement
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no redist-config <IPv6-Prefix> <Prefix-Length>
The parameters have the following meaning:
Parameter
Description
Range of values / note
IPv6-Prefix
IPv6 address
Enter a valid IPv6 address
Prefix-Length
Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The information for the route is deleted.
Further notes
You enable the ASBR router with the ASBR Router command.
You create the information with the
redist-config command.
You display the setting with the
show ipv6 ospf command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English