Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
88 Configuration Manual, 11/2015, C79000-G8976-C252-10
You disable the blocking of broadcast frames with the no broadcast-block command.
no broadcast-block
Description
With this command, you disable the blocking of broadcast frames on an interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameter assignment:
no broadcast-block
The blocking of broadcast frames is disabled.
You enable the blocking of broadcast frames with the broadcast-block command.
Electrical interfaces can be operated in full duplex mode or half duplex mode. The options
here depend on the connected device.
Optical connections are always operated in full duplex mode since they have a fiber for each
transmission direction.
With this command, you configure the duplex mode of an interface. The same mode must be
set for connected interfaces.
To Next Page
Loading...
Need help?
General