Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
60 Configuration Manual, 11/2015, C79000-G8976-C252-10
show interface mtu
Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
interfaces on the device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show interface mtu [{vlan<vlan-id(1-4094)>|
port-channel<port-channel-id(1-8)>|
<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel 1 ... 8
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If no parameters are specified, the settings for all interfaces are displayed.
The settings for the maximum transmission unit (MTU) of interfaces are displayed.
show interfaces
Description
This command shows the status and the configuration of one, several or all interfaces.
To Next Page
Loading...
Need help?
General