Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
506 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
show ipv6 ospf route
The routes are displayed.
show ipv6 ospf virtual-links
Description
This command shows an overview of the virtual connections of OSPFv3.
Note
This command is available only with layer 3.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameter assignment:
show ipv6 ospf virtual-links
The overview is displayed.
show ipv6 ospf area-range
Description
This command shows the grouped address ranges.
Note
This command is available onl
y with layer 3.
To Next Page
Loading...
Need help?
General