Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
285
Call up the command with the following parameters:
ipv6 neighbor <prefix>
{vlan <id> | [<interface-type> <interface-id>]}
<MAC ADDRESS (xx:xx:xx:xx:xx:xx)>
The parameter has the following meaning:
IPv6 address of the neighbor node
Enter a valid IPv6 address.
Keyword for a VLAN connection -
Number of the addressed VLAN
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Link layer address (MAC address) of the neighbor node
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The entry is configured.
You delete an entry with the no ipv6 neighbor command.
You display the IPv6 neighbor table with the
show ipv6 neighbors command.
no ipv6 neighbor
Description
With this command, you delete an entry from the IPv6 neighbor table.
● The neighbor node is located on the same link.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General