Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.8 SMTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
371
Syntax
Call up the command with the following parameters:
no smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN)> | ipv6 <ip6_addr>}
The parameters have the following meaning:
Parameter
Description
Note on the range if values
ipv4
Keyword for an IPv4 address
-
ucast_addr
IPv4 address of the SMTP server Enter a valid IPv4 unicast ad-
dress.
fqdn-name
Keyword for a domain name
-
FQDN
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6
Keyword for an IPv6 address
-
ip6_addr
IPv6 address of the SMTP server
Enter a valid IPv6 address.
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 39)".
Result
The SMTP server entry is deleted.
Further notes
You configure an SMTP server entry with the smtp-server command.
7.8.2.3
sender mail-address
Description
With this command, you configure the e-mail name of the sender.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
sender mail-address <mail-address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
mail-address
Email name of the sender
max. 100 characters

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English