Layer 2 management protocols
8.6 Multicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
424 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show mac-address-table static multicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Keyword for a MAC address
MAC address -
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
The static multicast MAC addresses are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
mac-address-table block static multicast
Description
With this command, you configure static multicast addresses that will be blocked.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General