Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
744 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
dot1x guest-vlan
The guest VLAN function is enabled for the device.
You also still need to enable the guest VLAN function for every port intended to use this
function. You do this with the
dot1x guest-vlan command in the Interface configuration
mode.
You disable the function with the
no dot1x guest-vlan. command
You display this setting and other information with the
show dot1x guest-vlan mac-info
command.
no dot1x guest-vlan
Description
With this command, you disable the guest VLAN function for the device.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no dot1x guest-vlan
The guest VLAN function is disabled for the device.
You enable the function with the dot1x guest-vlan. command
You display this setting and other information with the
show dot1x guest-vlan mac-info
command.
To Next Page
Loading...
Need help?
General