Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
548 Configuration Manual, 11/2015, C79000-G8976-C252-10
no ipv6 ospf transmit-delay
Description
With this command, you reset the interval to the default value.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
no ipv6 ospf transmit-delay
The interval is reset.
You enable OSPFv3 routing with the ipv6 router ospf command.
You configure the interval with the
ipv6 ospf transmit-delay command.
You enable OSPFv3 routing with the
ipv6 router ospf command.
This section describes the commands relevant for working with routing with VRRP.
The commands are only available with layer 3 and only in conjunction with VLAN
interfaces. Router ports are not supported
Enable routing to be able to use VRRP.
VRRP supports only IPv4. If you want to use IPv4 and IPv6, use VRRPv3
To Next Page
Loading...
Need help?
General