Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
606 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
It has been specified which RIP version incoming updates need to have.
9.6.4.5
no ip rip receive version
Description
This command specifies that there is no restriction relating to the version of received RIP
updates. Updates according to RIPv1 and RIPv2 are received.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameters:
no ip rip receive version
Result
All RIP updates are received.
9.6.4.6
ip rip send version
Description
This command specifies the RIP version for outgoing routing information.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English