Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
427
Call up the command with the following parameters:
no mac
-address-table static multicast <aa:aa:aa:aa:aa:aa> vlan <vlan
-id(1-4094)> The parameters have the following meaning:
MAC address of the interface -
Keyword for a VLAN connection
Number of the addressed VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default value is used.
The "static multicast" function is disabled.
This section describes commands for MLD snooping. MLD (Multicast Listener Discovery)
snooping only forwards multicast packets to the intended host instead of flooding all ports
with them.
This section describes commands with which you display various settings.
show ipv6 mld snooping
Description
This command shows the information about MLD snooping for all or a selected VLAN.
● MLD snooping is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General