Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
600 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
redistribute {all | default | connected | ospf | static} [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
all
All available route information is dis-
tributed.
-
default
Default routes are distributed.
-
connected
Routing information of local subnets (IP
interfaces) is distributed for which RIP
is not configured.
-
ospf
Routes learned by OSPF are distribut-
ed.
-
static
Static routes are distributed.
-
route-map
Keyword for a route map.
-
name
Name of the route map.
Maximum of 20 characters
Result
The information forwarded by RIP has been specified.
9.6.3.11
no redistribute
Description
This command specifies which route information is not forwarded by RIP.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English