Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
592 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show ip rip {database [<ip-address> <mask>] | statistic }
The parameters have the following meaning:
The information of the RIP database is
-
The destination address of the route for
which information is displayed.
Specify a valid IP address.
The subnet mask of this route.
Enter a valid subnet mask.
Statistical information is displayed, for
example the number of updates.
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The database or statistical information is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
Note
These commands are available only with layer 3.
With this command, you enable the RIP protocol and change to the Router configuration
mode.
To Next Page
Loading...
Need help?
General