Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
447
Call up the command with the following parameters:
show ip ospf request-list
[<neighbor-id>]
[{
vlan <vlan-id (1-4094)> |
<interface-type> <interface-id>
}]
The parameters have the following meaning:
Router ID of the neighbor Enter the router ID. The router ID
consists of 4 numbers each be-
Keyword for a VLAN connection -
Number of the addressed VLAN
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the request list is displayed for all
neighbors.
The request list displayed.
show ip ospf retransmission-list
Description
This command shows which queries are still open in the form of a list.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General