Siemens SCALANCE XR-500 Configuration Manual

System time
5.2 NTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
151
Syntax
Call up the command with the following parameters:
no time dst [<name(16>]
The parameter has the following meaning:
Parameter
Description
Range of values / note
name
Name of the entry
maximum 16 characters
Result
An entry or the entries for the start and end of daylight saving time was/were deleted.
5.2
NTP Client
This section describes commands relevant for configuration of the NTP client.
5.2.1
The "show" commands
This section describes commands with which you display various settings.
5.2.1.1
show ntp info
Description
This command shows the current settings for the Network Time Protocol (NTP).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ntp info
Result
The current NTP settings are displayed.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English