Network protocols
7.5 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
321
● DHCPv6 Is activated.
● The DUID is of the type
llt or ll
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 dhcp client-id interface {<interface-type> <interface-id>}
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Slot no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The IP interface is assigned.
You enable the function DHCPv6 client with the ipv6 address dhcp command.
You configure the DUID with the
ipv6 dhcp client-id type command.
DHCPv4 Relay Agent (IPv4)
This section describes commands for the DHCP Relay Agent.
This section describes commands with which you display various settings.
To Next Page
Loading...
Need help?
General