Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
508 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
show ipv6 ospf { request-list | retrans-list } [ <Neighbor-RouterID>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
request-list
Request list for which LSA information is re-
quired.
-
retrans-list
List with LSAs from which information was sent
but the acknowledgement of the recipient is
missing.
-
Neighbor-
RouterID
Router ID of the neighbor Specify the ID in the IPv4 address
format
x.x.x.x
x = 0 ... 255
If you do not specify a router ID, the list for all neighbors is shown.
Result
The list is displayed.
9.3.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
9.3.2.1
ipv6 router ospf
Description
With this command, you enable routing with OSPFv3 and change to the Router configuration
mode.
Note
This command is available only with layer 3.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English