Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
79
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>|port-channel<port-channel-id(1-8)>}
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 … 4094
Keyword for a port channel connection
Number of the addressed port channel
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 39)".
The logical interface is deleted.
You configure an interface with the interface command.
You display the status and the configuration of the interfaces with the
show interfaces
command.
cli-console-timeout
Description
With this command, you enable the automatic logout and you configure the timeout setting
for the CLI.
Note
No automatic logout from the CLI
If the connection is not terminated after the set time, check the sett
ing of the "keepalive"
function on the Telnet client. If the set interval is shorter than the configured time, the lower
value applies. You have set, for example, 300 seconds for the automatic logout and 120
seconds for the "keepalive" function. In this ca
se, a packet is sent every 120 seconds that
You are in the Global configuration mode.
The command prompt is as follows:
To Next Page
Loading...
Need help?
General