Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
578 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
vrrp <vrid(1-255)> accept-mode
The parameter has the following meaning:
The ping function to virtual IPv6 addresses is enabled.
You disable the ping function for virtual IPv6 addresses with the no vrrp accept-mode
command.
You assign IP addresses to a virtual router with the
vrrp associated -ip command.
You can display the status of the function with the
show vrrp3 interface - vrid or with the
show vrrp3 interface command.
no vrrp accept-mode
Description
With this command, you disable the ping function for virtual IPv6 addresses on the VRRP3
interface.
Note
This command is available only with layer 3.
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
To Next Page
Loading...
Need help?
General