Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.5 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
324 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
ip dhcp server <ip address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
ip address
IPv4 address of the DHCP server
enter a valid IP address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The IP address is specified.
Further notes
You remove the IP address with the no ip dhcp server command.
You enable the DHCP Relay Agent with the
service dhcp-relay command.
You display the IP addresses with the
show dhcp server command.
You display the settings with the
show ip dhcp relay information command.
7.5.2.2
no ip dhcp server
Description
With this command, you delete the IP address of the DHCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip dhcp server <ip address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
ip address
IP address of the DHCP server Enter the IP address to be delet-
ed.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English