Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
590 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
vrrp <vrid(1-255)> timer <interval(10-4095)centiseconds>
The parameters have the following meaning:
Time interval in hundredths of seconds 10 ... 4095
Default: 10
The time interval is specified.
You configure a VRRP3 interface with the interface command.
You enable routing with VRRP3 with the
router vrrp3 command.
You reset the time interval to the default with the
no vrrp timer command.
You assign IP addresses to a virtual router with the
vrrp associated -ip command.
You show the interval with the
show vrrp3 interface - vrid command.
no vrrp timer
Description
With this command, you reset the time interval to the default value.
Note
This command is available only with layer 3.
● Routing with VRRP3 is enabled.
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
To Next Page
Loading...
Need help?
General