Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
581
Call up the command with the following parameters:
no vrrp <vrid(1-255)> associated-ip [{ ipv4 <ip_addr> | ipv6 <ip6_addr> }]
The parameters have the following meaning:
Keyword for IPv4 address -
Enter a valid IPv4 address.
Enter a valid IPv6 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The IP address is removed from the virtual router.
You configure a VRRP3 interface with the interface command.
You display the IP addresses with the
show vrrp interface - vrid command.
vrrp compatible-mode
Description
With this command, you enable compatibility with VRRPv2. For configured IPv4 addresses,
when enabled, the VRRP router sends and receives VRRPv2 frames in addition to VRRPv3
frames. Only necessary when not all VRRP routers support VRRPv3.
Note
This command is available only with layer 3.
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
To Next Page
Loading...
Need help?
General