Diagnostics
12.6 Syslog Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
818 Configuration Manual, 11/2015, C79000-G8976-C252-10
The entries of the configured Syslog server are displayed.
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
events command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you configure the Syslog server.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
To Next Page
Loading...
Need help?
General