Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
491
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call up the command with the following parameters:
ip ospf message-digest-key <Key-ID (0-255)> md5 <md5-Key (16)>
The parameters have the following meaning:
Keyword for the password -
Password for authentication enter a password
Maximum length: 16 characters
The password and the ID are specified.
You delete the password with the no ip ospf message-digest-key command.
no ip ospf message-digest-key
Description
With this command, you delete the required password.
Note
This command is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
To Next Page
Loading...
Need help?
General