Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
541
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf metric
Result
The metric is reset.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You configure the metric with the
ipv6 ospf metric command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.11
ipv6 ospf passive-interface
Description
With this command, you deactivate the OSPF interface. The router then does not send any
hello packets on this interface and can also not establish a link via this interface.
Note
This command is av
ailable only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 ospf passive-interface

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English