Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
623
You display this setting and other information with the show ipv6 rip command.
You enable RIP routing with the
ipv6 rip. command.
ipv6 rip metric-offset
Description
As default. the metric increases by 1 (metric offset) with incoming RIPng routes. With this
command, you can specify a different offset. The RIPng route is further distributed with the
new metric.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
ipv6 rip metric-offset <integer (1-15)>
The parameter has the following meaning:
Metric offset 1 ... 15
The metric offset is configured.
To Next Page
Loading...
Need help?
General