Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
338 Configuration Manual, 11/2015, C79000-G8976-C252-10
7.6.4.3
ipv6 dhcp relay remote-id type
Description
With this command, you specify the type of the remote ID.
Requirement
● The interface is an IPv6 interface.
● The DHCPv6 relay agent is enabled.
● The Remote ID is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp relay remote-id type {duid | system-name | mgmt-ip | userDefined}
The parameter has the following meaning:
Parameters
Description
Range of values / note
duid
Uses the DHCP unique identifier
You configure the entry with theipv6 dhcp relay re-
mote-id duid command.
-
system-name
Uses the system name.
-
mgmt-ip
Uses the management IPv6 address
-
userDefined
Uses a user-defined entry
You configure the entry with the ipv6 dhcp relay re-
mote-id userDefined command.
-
Result
The remote ID is specified.
Further notes
You enable the DHCPv6 relay agent with the ipv6 address dhcp command.
You enable the remote ID with the
ipv6 dhcp relay remote-id. command.
You configure the interface as a router port with the
no switchport command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English