Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
172 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show mac-address-table static unicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Keyword for a MAC address
MAC address -
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
The static unicast MAC addresses are displayed.
show mac-address-table count
Description
With this command, you show the number of MAC addresses for all or a selected VLAN.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General