Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
303
The interface ID is configured.
You delete the interface ID with the no ipv6 interface-identifier command.
You display this setting and other information with the
show running-config command.
no ipv6 interface-identifier
Description
With this command, you delete the interface ID.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
no ipv6 interface
-identifier <prefix>
The parameter has the following meaning:
The interface ID has been deleted.
You configure the interface ID with the ipv6 interface-identifier command.
You display this setting and other information with the
show running-config command.
To Next Page
Loading...
Need help?
General