Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
556 Configuration Manual, 11/2015, C79000-G8976-C252-10
The function for pings to virtual addresses is disabled.
You enable the setting with the vrrp virtual-ping command.
You display the status of this function and other information in Privileged EXEC mode with
the
show vrrp command.
Commands in the Interface Configuration mode
This section describes commands that you can call up in the Interface configuration mode.
● The commands are only available with layer 3
● Enable routing to use VRRP.
● You can only use VRRP in conjunction with VLAN interfaces.
● VRRP only supports IPv4. If you want to use IPv4 and IPv6, use VRRPv3
Note
The commands are only available with layer 3 and only in conjunction with VLAN in
terfaces.
In the VRRP Router configuration mode, enter the interface command to change to this
mode.
Commands relating to other topics that can be called in the Interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
VRRP Router configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
vrrp associated-ip
Description
With this command, you specify which IPv4 addresses the virtual router monitors.
Note
This command is available only with layer 3.
To Next Page
Loading...
Need help?
General