Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
65
Call the command without parameters:
show pnio
The current PROFINET IO configuration is displayed.
show broadcast-block config
Description
This command shows the broadcast blocking settings for ports.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show broadcast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Keyword for a port description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The broadcast blocking settings for ports are displayed.
show unicast-block config
Description
This command shows the unicast blocking settings for ports.
To Next Page
Loading...
Need help?
General