Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
260 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|ospf|static|summary}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
ip-address
The destination address of the route.
Enter a valid IPv4 address
mask
Defines an address range using the
subnet mask.
/8, /16 or /24
connected
Shows the network routes with a direct
connection.
-
ospf
Shows the OSPF entries in the routing
table.
-
rip
Shows the RIP entries in the routing
table.
static
Shows the static routes in the table.
-
summary
Shows a summary.
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The IPv4 routing table is displayed.
7.1.1.2
show ip static route
Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip static route
Result
The static routes are displayed.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English