Configuration
3.5 PoE
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
123
Call the command without parameter assignment:
no poe pse usage
The parameter "Usage Threshold" is set to 80%.
Commands in the Interface Configuration mode
3.5.3.1
Introductory sentence for the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
Note
The interface is a Gigabit Ethernet interface.
With this command, you activate PoE for the interface in whose interface configuration mode
you are currently working.
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-Gi$-$)#
The placeholders $-$ stand for the numbering of the interface.
To Next Page
Loading...
Need help?
General