Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
646 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
set metric <value(0-0xffffff)>
The parameter has the following meaning:
Value of the metric 0 ... 0xffffff
Enter the new value for the metric with which the routing
information will be forwarded.
You can enter the value in decimal or hexadecimal.
The routing information is forwarded with a changed metric.
You delete the setting that the metric of the routing information is changed with the no set
metric
command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
no set metric
Description
With this command, you delete the setting that the metric of the routing information is
changed.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General