Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
207
This command shows the information about the settings and information about the ports
involved in the link aggregation. The number of sent and received packets is also displayed.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show lacp [<port-channel(1-8)>]{counters|neighbor[detail]}
The parameters have the following meaning:
Number of the Channel-Group
Shows the values of the counters
Displays information on neighbor ports
Displays detailed information on neigh-
-
If you do not select a port channel, information for all available interfaces is displayed.
The information is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General