Siemens SCALANCE XR-500 Configuration Manual

Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
435
8.7.3
Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
vlan $$$ command to change to this mode.
When doing this, you need to replace the
$$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
8.7.3.1
ipv6 mld snooping
Description
With this command, you enable MLD snooping on the device or on the required VLAN.
For MLD snooping to work, you need to enable the function globally and in the VLANs. In the
Global configuration mode, enable MLD snooping on the device or globally. To enable MLD
snooping on the required VLAN, execute the command in the VLAN configuration mode.
Requirement
● GMRP is disabled.
● You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 mld snooping
Result
MLD snooping is enabled.
Further notes
You disable GMRP with the no grmp command.
You disable MLD snooping with the
no ipv6 mld snooping command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English