Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
532 Configuration Manual, 11/2015, C79000-G8976-C252-10
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
ipv6 ospf area
Description
With this command, you enable OSPFv3 on the interface and assign it an OSPFv3 protocol
instance..
nd is available only with layer 3.
● The interface is an IPv6 interface.
● The router ID is configured.
● OSPFv3 routing is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
To Next Page
Loading...
Need help?
General