Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
452 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
The commands are available if the following requirements are met:
● The device supports the routing function.
● The routing function is enabled.
9.2.3.1
ASBR Router
Description
With his command, you specify that the router is an Autonomous System Boundary Router
(ASBR).
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call the command without parameters:
ASBR Router
Result
The autonomous system boundary router is enabled.
Further notes
You disable the autonomous system boundary router with the no ASBR Router command.
You can display the status of this function and other information with the
show ip ospf
command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English