Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
535
The parameter has the following meaning:
Interval in seconds 1 ... 65535
Default: 40
The value must be a multiple of the hello interval.
The routers located on the same link must have the
The interval is specified.
You display the configuration with the show ip ospf interface command.
You enable OSPFv3 routing with the
ipv6 router ospf command.
You can reset the interval to the default with the
no ipv6 ospf dead-interval command.
no ipv6 ospf dead-interval
Description
With this command, you reset the interval to the default value.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
no ipv6 ospf dead-interval
To Next Page
Loading...
Need help?
General