Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
767
Call up the command without parameters or with the following parameter assignment:
cabletest interface <interface-type> <interface-id> [force]
The parameters have the following meaning:
Enter a valid interface.
Interface identifier
Forces a link down during the test Necessary parameter if there is a
link up on the interface.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default value is used.
Following the test phase, the result is displayed.
The value for the distance has a tolerance of +/- 1 m.
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
events command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you create an entry in the log.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
To Next Page
Loading...
Need help?
General